mode mille 2008
12bps\s
E2 / Zero B
1. Fit fresh batteries to the loader that will be used and set the loader speed as required 2. Enter the Setup menu 3. Select (MODE) and choose the RAMP 3** option 4. Set the COFF parameter to 40ms 5. Enable the breech sensor 6. Shoot the gun so that it ramps and measure the ROF on a rate of fire meter 7. Adjust the COFF parameter and repeat 6 until the ROF is 11.8bps* (increasing COFF reduces ROF) 8. Check that CDELAY + CON + COFF is greater than 84ms and if not then increase CON 9. Exit the Setup menu 10. Check the rate of fire on a league approved ROF meter.
E1 (eBlade)
1. Fit fresh batteries to the loader that will be used and set the loader speed as required 2. Enter the Setup menu 3. Set the COFF parameter to 40ms 4. Enable the breech sensor 5. Shoot the gun as quickly as you can and measure the ROF on a rate of fire meter 6. Adjust the COFF parameter and repeat 5 until the ROF is 11.8bps* (increasing COFF reduces ROF) 7. Check that CDELAY + CON + COFF is greater than 84ms and if not then increase CON 8. Exit the Setup menu 9. Check the rate of fire on a league approved ROF meter.
*The rate of fire settings on Egos are accurate however not all rate of fire meters will read the same. We recommend that guns be set on the safe side of the legal limit. The difference between 11.8 and 12.0bps is only 1 extra ball every 59 shots!
**If your software does not have the RAMP 3 option then it will be necessary to upgrade your software to the latest version.